Make a solution by adding 8-10 drops of a mild, non-moisturizing dish detergent (Dawn or Joy do not use hand soap) to a 32-oz. Wetting solution is the secret ingredient to a smooth, seamless installation. But don’t skip steps or skimp on tools! For a beautiful and resilient end result, take your time, measure carefully, wet thoroughly and squeegee the entire surface. With the right preparation and installation, static cling Decorative Films are a fast and easy way to transform a room. The film will completely dry and fully adhere within a few days. Once the film is trimmed, wrap the hard card in a paper towel and use it to push any remaining bubbles and water to the outside edge. Then, in one smooth, continuous motion, trim the excess film from the edges using the hard card and a razor knife. If any bubbles remain, use the hard card to push them towards the edge. Locate the hard card and razor that were included with your film. Squeegee from the center moving out, pushing bubbles and wrinkles out as you go.ĭouble check that the film is flat and smooth. Wet the outside of the film with the spray, then slide a squeegee over the wet film to smooth out and press the film against the glass. The water should allow it to float and flow easily. Move, slide and reposition the film as needed. Place the wet film onto the wet surface, keeping the top edge level but letting the film hang over the edges of the frame on all sides. Pick up the film by the top corners, keeping it straight and level. The water will allow you to easily apply and reposition the film before you squeegee—and any excess water will evaporate as the film fully adheres. Wetter is better! There is no such thing as too much water. Thoroughly spray and soak the glass surface AND the adhesive side of the film with the water mixture. Wet fingers will prevent fingerprints on the adhesive surface. After you remove the liner, rinse and dip fingers in water before handling the film. If you are working with a large piece of film, it is helpful for two people to work together. If you can’t separate the liner from the film, place a piece of scotch tape on both sides of the sheet, fold the tape over to create tabs, and use the tabs to separate the two sides. Slowly peel back the liner, wetting the adhesive side of the film very thoroughly as you peel down. Lay the film on a clean, flat surface with the liner facing up. Use low-lint towels or microfiber cloths to clean the surface, as lint left on the glass can stick under film. Thoroughly clean the surface of the glass to remove any trace of dust, grime and grease. If you’re unsure about measuring, make a paper template of your window and use it to measure and cut your film. You may use the paper liner on the back of the film to mark cut points this will not damage the film. You’ll be able to trim the edges down to size in the final step. Cut the film to the dimensions, leaving an extra ½ inch to 1 inch around all sides. StepsĬarefully measure the height and width of the glass surface. This can cause dust and debris to blow onto your film and become trapped. Do not run a fan near the film or glass surface during installation. You will need enough flat surface to lay out the film for measuring, cutting, marking and prep. Use a glass-safe scrub pad to remove the debris. If you hear a clicking sound, there is something on the surface that will prevent full adhesion. To ensure the surface is completely clean and smooth before installation, spray the glass with the soapy water mixture and drag a single-edge razor across the surface. More soap may be needed when applying film to acrylic surfaces. spray bottle filled with clean water (adjust ratio for smaller or larger bottles). With the right preparation and installation, Decorative Films are a fast and easy way to transform a room.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |